Vacon® Opte9 Dual Port Ethernet Drive Support - Vacon optea Installation Manual

vacon • 28
5.2 VACON
®
The VACON OPTE9 Dual Port Ethernet option board can be used with the following VACON
drives.
AC drive
VACON
VACON
®
VACON
and 100 X
VACON
VACON
VACON
®
VACON 100 family support
®
The VACON 100 family AC drives are supported from the OPTE9 firmware version V003. The
process data in VACON
for later firmware release. Only 16-bit process data is supported.
EtherNet/IP support
EtherNet/IP protocol was added to OPTE9 firmware version V004. The table below shows required
minimum AC drive firmware version .
5
®
OPTE9 Dual Port Ethernet drive support
Table 12. OPTE9 supported AC drives and slots
®
NXP
®
NXS
100 INDUSTRIAL
®
100 FLOW
®
20
®
20 X and CP
®
100 family AC drives is 32 bit. The 32-bit process data support is planned
Table 13. Required minimum AC drive firmware versions
AC Drive
®
VACON NXP
®
VACON NXS
®
VACON 100 INDUSTRIAL and
100 X
®
VACON 100 FLOW
®
VACON 20
®
VACON 20 X and CP
From AC drive SW
Slots
version on
D, E NXP00002V188
D, E NXS00002V179
D, E FW0072V018
D, E FW0159V012
- FW0107V011
- FW0117V007
From AC drive SW version on
NXP00002V191
NXS00002V181
FW0072V018
FW0159V012
FW0107V012
FW0117V009
Local contacts: https://www.danfoss.com/en/contact-us/contacts-list/
Installation
®
AC
From OPTE9 SW
version on
V001
V001
V003
V003
V002
V002