Operation - Nordson 3100V Series Customer Product Manual

4
RTD-Style Hot Melt Hose
lnstallation
and
Electrical
Connections
Operation
a
WARNING:
Failure to follow
the safety procedures can result
in
injury or death.
Allelectrical, pneumatic,
gas, and hydraulic connections and
installations of hot melt equipment may only be carried out by
qualified personnel.
Be sure to
observe installation instructions for
components and accessories.
Equipment must be properly grounded
and
fused according to
its
rated current
consumption (see lD plate).
Cables which
run
outside the unit must regularly
be
checked for
wear
or damage.
Power supply
wire gauge and insulation must
be
sutficient
to handle
rated current consumption.
Cables must never be squeezed or pinched. Do not locate cables or
hoses in high traffic areas.
The unit should
be operated by
qualified personnel in accordance with
the instructions presented
in
this document.
WARNING:
Failure to
follow the safety procedures can result
in
injury or death.
Never allow the unit
to
be
operated by personnel under the influence
of substances
which reduce their reaction times,
or
who are not able
to operate the equipment for physical reasons.
Prior to each start-up
of
the unit,
check protection and warning
devices and make sure they
are
fully
functional.
Do not operate
the
unit
if
these devices are
not
functioning properly.
When
the removal of safety equipment is required for installation,
maintenance,
or repair
of
the unit, it must be re-connected
immediately upon completion
of the work.
Prior to start-up
of
the unit, check to make sure all safety guards and
safety equipment are
in
place
and
functioning properly.
a
a
a
a
a
a
a
a
Manual 45-21
1
08 232E
lssued 1/00
@
2000 Nordson Corporation
All
rightrs
reserued