Magnet Assembly Lnstallation - Nordson 3100V Series Customer Product Manual

B
1-32
Hydraulics
Magnet Assembly lnstallation
See
the illustrations in
Magnet
Assembly Removalas you
perform the
following
reassembly
steps.
You
can
also use
the actuator parts
list
illustration
at
the end
of
this section.
CAUTION:
Risk of
equipment damage.
lf
you
use
a
vise to
hold the
valve
body
while
removing the
magnet assembly, place
the vise
jaws
on
the sides of the valve body, not on the
machined surface that mounts to the air cylinder.
1.
Thread the
magnet assembly into the
valve
spool until
it seats
2.
Slip an awlthrough the hole in the
magnet
assembly
shaft.
3.
Using an adjustable
wrench,
hold the
bumper
flats
and screw
the
magnet
assembly
into the valve spool.
Tighten to
9-11 N.m (81-99
in.-lb).
4.
Slide
the
can over the magnet assembly so the opening faces the
pump assembly. lnstallthe securing
screws and tighten them
to
3-4 N.m (28-36
in.-lb).
5.
lnstallthe valve cap.
Tighten the valve cap screws
to
3-4 N.m (28-36
in.-lb).
6.
lnstallthe
actuator:
NOTE:
Series
3100t1
3400t4
and 3500Vunits
have
a pump cover
bracket that must be installed when the
actuator is
installed.
See
Figure B
1-19.
a.
Move
the
hydraulic
shaft
up or down until the shifter fork is in the
center
of
the
pump mount.
b.
Carefully align the actuator with the
shifter
fork
and
the
locating
pins on the
air cylinder.
c.
lnstall the actuator with the'screws
and
washers you
removed
earlier.
Tighten to
3-4 N.m (28-36
in.-lb).
7.
Connect the air input line to the actuator.
8.
Replace the
pump cover, restore power and air
to the unit, and
resume operation.
I
a
B't
EN-02-[3V-X-AGXX]-2
41-3000y
lssued 5/00
@
2000 Nordson Corporation
All righls reserved