To Change A Standby Or Heater Time - Nordson 3100V Series Customer Product Manual

lnstallation
A 3-45
3.
See Figure A
3-26.
Press
the Up key below the Selector display to
select
the day code (1)for which you want to set
a time.
4.
Press
the Enter key (4) to save the day code setting. The Selector
display stops
flashing and the hour (2) shown in the Multipurpose
display flashes.
5.
Press
the Up or Down keys (5) below the Multipurpose display until
the hour for which you want to set
a
time appears
in
the display.
6.
Press
the Enter key to save the hour setting. The hour shown
in
the
Multipurpose display stops flashing and the minutes flash.
7.
Press the Up or Down keys until the minutes (3) for which you want to
set
a time
appear on the Multipurpose display.
L
Press
the Enter key to save the minutes setting. All displays stop
flashing.
9.
Record
your setting
in the
forms provided at the end
of this section
Refer
to Records of
System Settings.
10. To set a
second time for the same day, press the Move Right key until
the
INTERVAL
2
light turns
on.
Press the Enter key to save the day
and repeat steps 5 through
9.
To
Change a Standby or Heater Time
To
change
a
set time, follow the procedure for setting the standby and
heater times.
@0O0 Nordson Corpotalion
All
rights reserued
41-3000y
lssued 5/00
A3EN-04-[3V-X-4XXVI-1
3