Programming Clock Controls A - Nordson 3100V Series Customer Product Manual

lnstallation
A 3-39
Prog ram
m i
ng
C
LOC
K Controls
3.
ln the Display area, press the Up key below the Selector display
until
0 (Set All) appears on the display. All three zone-type lights tum
on and
the Multipurpose display shows a default temperature of
177
"C (350.F).
4.
Press the Up or Down keys below the Multipurpose display to change
the temperature. The
Multipurpose display flashes.
5.
Press
the Enter key to change the temperature setting of all zones
that are turned on to the temperature shown
in
the tilultipurpose
Display. The display stops flashing.
NOTE: When you
exit the Set
Allfeature,
it always returns to the
default setting
ot
177
'C (350 "F).
6.
Record your setting
in the
forms provided
at
the end
of
this section
Refer
to Records of System
Settings.
The seven-day clock feature turns the heaters on and off
or
takes the unit
into and out
of
the standby mode at preset times that you program. This
feature works in conjunction with the clock on the unit, which keeps the
correct day and
time.
lt
does not matter whether you set the current day
and time
first, or set the standby and heater times.
However, both
features must be set for the heaters to turn on and off correctly.
NOTE:
lf
you experience a power outage, the unit's internal clock will
continue to keep
time.
Once power is restored and the unit
is
turned on,
the unit will resume normal operations. You do not need to reprogram
any
features controlled
by
the clock.
NOTE: The clock does
not automatically adjust for seasonal time shifts,
such as daylight savings time.
@
2000
Nordson
Corporation
All
riqhts reserved
41-3000y
lssued 5/00
A3EN-04-[3V-X-4XXVI-1 3