Nordson 3100V Series Customer Product Manual page 239

B
2-6
Control
Opening
WARNING:
Risk of
equipment damage, personal
injury or
death.
Disconnect and lock out electrical power to the unit,
including inpuVoutput
(l/O) lines.
1.
Place the unit's POWER switch
in
the off position, disconnect and
lock out
electrical power to the unit at the branch circuit disconnect
switch, and disconnect and lock out electrical power supplied through
any l/O wiring.
2.
See Figure
B
2-3.
Loosen the captive screws on the electrical
enclosure lid,
lift
the lid from the unit, and prop it against the pump
cover.
Take
care not to disconnect the ground wire.
3.
Make sure
the support strap is not wrapped around any board
components.
Untangle
the strap if necessary.
4.
Loosen the two captive screws on either side
of the control-end frame
and lower the frame.
You
may need to pull the front and rear covers
apart
to
release the frame.
5.
Avoid direct contact with internal electrical connections, components,
or wiring.
6.
Make
sure all ground wires are securely connected.
t
t'
41308494
Fig. B
2-3
Opening
the Electrical
Enclosure
82
EN-04-[3V-X-4XXyI-s
41-3000v
lssued
5/00
e000
Nordson
Coporation
All
rights reserved