An Example Of How To Use The Seven-Day Clockfeature - Nordson 3100V Series Customer Product Manual

lnstallation
A3-47
8.
System Preparation
Filling the
Tank
with
Adhesive
An Example of How to Use the Seven-Day Clock Feature
At one company,
the production line runs for two shifts each day and
shuts down on
weekends.
Both shifts shut down for 45 minutes twice
each
day:
once
at 12:00 noon for lunch and again at 6:00
in
the evening
for dinner.
By using the clock feature, the company can have the unit
start and stop by setting the clock feature to
Put
the unit into the standby mode (ENTER STANDBY) at 12:00
P.M.
(INTEHVAL
1) and again at
6:00
P.M.
(INTERVAL
2).
Take
the unit out
of
the standby mode (EXIT STANDBY) at 12:30
P.M.
(INTERVAL
1)
and at 6:30
P.M.
(INTERVAL 2), allowing 15 minutes
for the system to reach application temperature.
Turn
the heaters on (HEATERS ON) Monday through Friday
30
minutes before the start
of
the
first shift (INTERVAL
1).
Turn
the heaters off (HEATERS OFF) Monday through Friday
at
the
end of the second
shift (INTERVAL
1).
NOTE: The
clock is not set
for Saturday or Sunday when the company is
closed.
Follow
these procedures to flush the system and prepare
it for
first
operation. This part of
lhe lnstallation section also includes the
procedure for adjusting the pressure control valve on gear pump units.
WARNING:
Allow only qualified
personnelto operate the
unit.
Use
this procedure to fill the tank with unmelted adhesive.
Before
continuing, refer to
General Hot Melt Material Processing lnstructions at
the beginning
of
this manual.
1.
lf
you have not already done so, program your unit.
Refer
to System
Programming Procedures
in this section.
2.
Open the
tank
lid
a
a
a
a
@
2000 Nordson Corporation
All rights reserved
41-3000y
lssued 5/00
ASEN-04-[3V-X-4XXVI-1
3r