Temperature Atea; System Settings Area; Clock Area A2-15 - Nordson 3100V Series Customer Product Manual

Description
A2-15
TEMPERATURE ATea
From the TEMPERATURE area you can program the setpoint and
standby temperatures for three types of heated zones: internal, hose, or
gun.
When used
in the TEMPERATURE area,
o The Move Up and lt/ove Down keys select SETPOINT or STANDBY
a The Move Right key selects the zone type (internal, hose, or gun)
for:
prog ram
min
g temperatu res (standby or
setpoi nt).
SYSTEM SETTINGS
Area
From the SYSTEM SETTINGS area you can customize or check the
settings
of
the
following system features:
.
password enable
.
system-ready time delay
o
overtemperature setpoint
o
Celsius or Fahrenheit units
o
globaltemperaturebands
o
individualtemperaturebands
o
sequential startup or simultaneous startup
.
display heater proportioning
.
warning or power notification
.
ready or
pump notification
o
auto-energize pump
o
auto-energizeheaters
o
time with heaters
on
o
fault log display
.
auto-energize pump temperature setting
CLOCK Area
From the CLOCK area you can program the system to turn heaters on or
off
or
to place the system in standby or operating mode at a time that you
select. The clock
stores two sets of times, referred to as
intervals.
Each
interval stores
four settings as shown
in
Table A2-2.
Table A
2-2
lnterval Settings
INTERVAL
1
INTERVAL
2
Standby Settings
Heater Settings
Enter
Exit
On
off
Enter
Exit
On
off
@ 1999 Nordson Corporatlon
All rights reserved
41-3000y
lssued 2/99
A2
EN-03-[3V-4-AXXVI-2