Power Board Lnstallation B - Nordson 3100V Series Customer Product Manual

Control
B 2-33
I
a
5.
Remove the mounting hardware from the power board.
CAUTION:
Bisk of equipment
damage.
Do not bend the
XPl
connector pins.
6.
Starting from the edge opposite the XP1 connector, carefully separate'
the power board from the control
board.
Take
care not to bend the
XP1
connector pins that join power board and control board.
NOTE: The
XP1
connector may remain attached to the power board.
lf
it
does, remove
it
and attach
it
to connector XP3 on the control
board.
NOTE:
lf
the optional l/O board
is connected to the control board on
your unit, take care not to damage the l/O board as you remove the
power board.
Power Board lnstallation
1.
Remove the new board from its static-safe container.
Handle
the
board by its edges without touching any pins, wires, or circuitry.
2.
See Figure
B
2-8.
Align
XPI
on
the new power board with the
connector pins on the control
board.
Press
the board into place,
making sure
the connector pins are properly inserted into their
sockets.
Fig.
B
2-8
Aligning the XP1 Connector
Pins
oo
oo
oo
oo
4130084
*foio
s!€
o
@00
Nordson
Corpoiallon
All
rights reserued
4'l-3000y
lssued 5/00
82 EN-04-[3V-X-4XXV1:.5