Nordson 3500 Series Operator Card

Nordson Corporation
OPERATOR'S CARD
P/N 106 921A
Series 3500/3700
Hot Melt Material Applicator
with Piston Pump, MultiScan

Please Note

The operator's card contains only information necessary
for daily operation and maintenance. For other
information, refer to the product manual.
A copy of this operator's card and an order form for
another operator's card are included in the Introduction
part of the operating manual.
WARNING: Allow only qualified personnel to
operate and maintain the unit. Observe the safety
instructions in the operating manual and the safety
symbols.

Safety Symbols

The following symbols warn against dangers or possible
sources of danger. Become familiar with them! Failure to
heed a warning symbol could lead to personal injury
and/or damage to the unit or other equipment.
WARNING: Failure to observe may result in
personal injury, death, or equipment damage.
WARNING: Risk of electrical shock. Failure to
observe may result in personal injury or death.
WARNING: Disconnect equipment from line
voltage.
Issued 9/94
r
Controller and Manifold C
S Always follow the instructions given in the operator's
card and operating manual.
S Always follow instructions in the material supplier's
Material Safety Data Sheet (MSDS) or material
information sheet.
S Even at recommended operating temperatures, hot
melt material may release vapors. Exceeding
prescribed processing temperatures for long periods of
time can result in dangerous decomposition
by-products. Remove vapors by drawing them off with
an exhaust system.
WARNING: Hot! Risk of burns. Wear
heat-protective clothing, safety goggles, and/or
heat-protective gloves depending on the symbol or
symbols shown.
WARNING: Pressurized system or material.
Release pressure. Failure to observe may result in
serious burns.
1. Turn the motor OFF.
2. Trigger all guns or adhesive head.
3. Open the manifold drain valve.
1 O1EN–10–[35–37C3]–6