lnstallation
A 3-25
Closing
the
Electrical
Enclosure
After you have completed electrical installation, follow this procedure to
close the electrical enclosure.
1.
Reconnect any ground
wires that may have become disconnected
during electrical installation.
2.
Raise the control-end
frame into place and tighten the captive screws
on
each side
of
the
frame.
You may need
to pull the front and rear
panels apart
to position the frame.
3.
Position
the electrical enclosure lid
on
top of the unit and secure it
with
the captive screws.
4.
Remove
the lock-out and turn on the power
at
the branch circuit
disconnect switch.
@000
Nordson
Corporation
All
rights reserued
41-3000v
lssued
5/00
A3EN-04-[3V-X-4XXVI-1
3