Control Board Lnstallation B - Nordson 3100V Series Customer Product Manual

Control
B 2-35
Control Board lnstallation
1.
Remove the new board from its static-safe container.
Handle
the
board by its edges without touching any pins, wires, or circuitry.
2.
See Figure
B
2-9.
Align
the XP4A connector pins (2) with the
connector (1)
on
the display board, then carefully press the control
board into place.
1
2
4130078A
Fig.
B
2-9
Aligning the XP4A Connector
1.
XP4A
connector
2.
XP4A connector pins
3.
Reinstallthe mounting
hardware.
Be sure to use lock washers on the
two screws located at the two ground pads on the control board.
Tighten
allscrews to2.0-2.3 N.m (18-20
in.-lb).
NOTE:
See Figure B 2-14 for an exploded drawing of the control
assembly parts.
4.
Connect all other harnesses, ribbon cables, and other connections to
the control board.
NOTE:
lf
your unit has the optional l/O board, you must also connect
this board to the control board.
Refer
to
Series 3000V lnput/Output
Boardinthe
Options section
for instructions on l/O board installation.
5.
lnstallthe power
board. Go to step
2in
Power Board lnstallation.
@ 2000 Nordson Corporation
All dghts reserued
41-3000y
lssued 5/00
82EN-04-[3V-X-4XXVI-5