Operator Panel Lnstallation - Nordson 3100V Series Customer Product Manual

B
2-38
Control
Operator Panel lnstallation
1.
Remove the new operator panel from its static-safe container.
Handle
the panel by its edges without touching the ribbon cable pins.
2.
With clean hands, peel the paper backing from the operator panel.
Be sure
to remove
allthe
paper, especially around the ribbon cable.
3.
See Figure B 2-11.
Connect
the plastic ground tab, which is located
behind
the Selector display, to the operator panel by lifting the tab up
and pressing it against the adhesive backing.
4130099A
Fig.
B
2-11
Connecting the
Ground Tab
4.
lnsert the ribbon cable through the hole in the control-end frame and,
starting from the ribbon strip side
of
the operator panel, carefully align
the operator panel on the control-end frame.
CAUTION:
Mount
the operator panel on a clean, smooth
surface.
Otherwise,
the panel may lose contact and cause poor
unit
performance. Additional damage can occur if operators
attempt
to
run
the unit using a panel that is not securely
mounted.
5.
Firmly press the panel into place with a rubber roller or similar tool.
6.
Loosen
the captive screws and lower the control-end frame. Connect
the ribbon cable to XP1
on
the control board.
7.
lnstall
the power board, connect the electrical service, and close the
electrical
enclosure. Golo Power Board lnstallation and System
Restoration in Replacing a Control Assembly Board.
I
a
82EN-04-[3V-X-4XXVI-5
41-3000v
lssued 5/00
@000
Nordson Corporation
All
dghts reserved