To Lnstall Hose Connector Or Plug O-Rings - Nordson 3100V Series Customer Product Manual

Maintenance
A 5-5
4103397
Fig. A
5-4
Removing a Hose
Connector
4t03398
Fig. A
5-5
Threading a Hose
Connector into a Hose
Port
7.
See Figure A
5-4.
Use an open-end
wrench to remove the hose
connector
from the hose port.
8.
Remove the o-ring from the hose connector.
To
lnstall
Hose
Connector or Plug O-Rings
CAUTION:
Use only Nordson
Viton
o-rings. Other o-rings
can
cause leaks.
1.
Check that
the new o-ring and the threads
of
the hose port are free of
debris. Lubricate
the o-ring groove with o-ring lubricant.
CAUTION:
Do not stretch
the o-ring more than necessary.
Stretching
the o-ring can cause leaks.
2.
Stretch
the o-ring and roll it over the threads
of
the hose connector or
plug so
that it rests
in
the o-ring groove.
3.
Lubricate the
threads
of
the hose connector or hose plug with Teflon
paste.
4.
See Figure A
5-5.
Thread
the connector or plug by hand into the port
on
the
unit.
@998 Nordson Corporation
All rights reserved
41
-3000y
lssued 9/98
A5EN-07-[3V-X-AXAX]-5