To Delete A Standby Or Heater Time; To Delete Times For An Entire Day - Nordson 3100V Series Customer Product Manual

A
3-46
lnstallation
To
Delete
a Standby or Heater Time
Follow
this procedure to delete a Standby or Heater set time.
1.
From
the System Setup area, press the Move Up and Move Down
keys until the light next to the feature you wish to change turns
on.
NOTE:
lf
you have enabled the password feature, you must change
the number
in
the Multipurpose display (500) to the password (321)
and press the Enter key before the system will allow you to change
the clock settings.
2.
Check the Selector display. The display flashes the day code
representing a day
of
the week.
3.
Refer to
llable A 3-9, and press the Up key below the Selector display
until the day code
of
the day that you want to change appears
in
the
Selector display.
4.
Press the Enter key to save the setting. The Selector display stops
flashing and the hour shown
in
the
Multipurpose display flashes.
5.
Press the Up or Down keys below the Multipurpose display until four
dashes
(-
- - -) appear
on
the display. (The dashes indicate that no
setting has been entered.)
6.
Press
the Enter key to save the setting. All displays stop flashing.
7.
Record
your setting in the forms provided
at
the end
of
this section.
Refer
to Records
of System Settings.
To Delete Times for
an
Entire Day
To delete times for an entire
day, follow
the procedure
To
Delete a
Standby or Heater Time
and turn
the clock otf for each feature: entering
standby, exiting standby, turning heaters on, turning heaters
off.
A3EN-04.[3V-X-4XXVI-1 3 4'l-3000v
lssued
5/00
e000
Nordson Corporation
All rights reserved