Nordson 3100V Series Customer Product Manual page 43

A1-4
Safety
5.
lnstallation and Electrical
Connections
6.
Operation
WARNING:
Failure to
follow the safety procedures can result
in
injury or death.
All electrical, pneumatic, gas, and hydraulic connections and
installations of hot melt equipment may only be carried out by
qualified personnel. Be sure to observe installation instructions for
components and accessories.
Equipment must be properly grounded and fused according to
its
rated current consumption (see lD plate).
Cables
which run outside the unit must regularly
be
checked for wear
or damage.
Power
supply wire gauge and insulation must be sufficient to handle
rated
current consumption.
Cables must never be squeezed or pinched. Do not locate cables or
hoses in high traffic areas.
The unit should be operated by qualified personnel in accordance with
the instructions presented
in
this document.
WARNING:
Failure to
follow the safety procedures can result
in
injury or death.
Never allow
the unit to be operated by personnel under the influence
of
substances which reduce their reaction times, or who are not able
to operate the equipment for physical reasons.
Prior
to each start-up
of
the unit, check protection and warning
devices and make sure they are fully functional. Do not operate the
unit
if
these devices are not functioning properly.
When the removal
of
safety equipment is required for installation,
maintenance, or repair
of
the
unit, it
must be re-connected
immediately upon completion
of
the work.
Prior
to start-up of the unit, check to make sure all safety guards and
safety
equipment are in place and functioning properly.
a
a
a
a
a
a
a
Al EN-02-[XX-SAFE]-1
lssued
11/94
O
1994
Nordson
Corporation
All
rights reserved