Wiring Requirements; Hose/Gun Power Requirements A - Nordson 3100V Series Customer Product Manual

lnstallation
A 3-3
Wiring Requirements
Hose/Gun Power Requi rements
Follow
these guidelines when installing wiring to the unit:
Allow
enough room to
route
your electrical service line to the unit.
You
can use either
of
the two access holes
in
the base
of
the unit for
electrical seruice.
One hole is
for rear access and the other
is
for
bottom access.
Route any wires away from AC power lines, solenoid output lines,
and electrical equipment such as motors, contacts, and relays.
Make connections with the minimum length of wire
needed. A
long
wire can act as an antenna for electrical noise.
a
The power requirements of your hoses and guns must be determined to
make sure that you do not overload the unit.
lf
your Nordson
representative
has not already checked to see that your unit can support
all of
the hoses and guns you plan to install, you need to calculate your
hose/gun power requirements now.
You
also need to check your
calculations
if
you change your system
configuration or add new hoses
and guns.
To
determine your hose/gun power requirements, refer lo
Calculating
Hose/Gun Capacity al the end
of
this
manual.
lf
you need help with this
procedu re, contact
you
r
Nordson representative.
@
2000 Nordson Corporation
All
rights reserved
41-3000v
lssued 5/00
A3 EN-04-[3V-X-4XXVj-1 3