Safety Precautions; Daily Maintenance - Nordson 3100V Series Customer Product Manual

20
RTD-Style Hot Melt Hose
4.
Maintenance
Preventive
maintenance procedures for
Nordson hoses consist of
periodic inspections,
cleaning,
and material changeover. Only
the
unit
end and
gun
end
electrical plugs
are field serviceable. The kits are listed
in
Section
6.
Attempting any other repair procedure can result in damage
to
the hose,
improper
system
operation, or
pbrsonal
injury.
WARNING: Before performing
any
maintenance on
any
hose,
thoroughly review safety information in Safety, Section
1
Failure
to
review
the
safety section, can result
in
equipment
damage, personal
injury or
death.
Also, follow the specific
safety precautions contained
in
this section.
WARNING: Allow only qualified personnelto perform
maintenance,
repair, and troubleshooting
tasks.
Performing
activities
not
described
in
this manual may result in personal
injury
death, or
equipment
damage.
WARNING:
To ensure
safe hose and gun
operation, do not use
non-conductive pipe
compound or tape on
hose and gun
hydraulic connections. Also,
make sure that the
hose and gun
are connected hydraulically
before
you
connect the hose
electrically
to
the
applicator.
NOTE: Keep
hot melt adhesive
material off
the
braid of
the hose. Built
up material
can cause
kinking when
the
hose is moved
from one position
to another.
WARNING: Hot.
Risk
of
burns. Hot applicator
parts, splashed
hot
melt
adhesive material, and hot gun surfaces
can cause
severe
burns.
Wear
heat-protective
clothing, safety goggles,
and safety gloves while
replacing hoses.
1.
With safety
gloves on, wipe
off any hot melt material on the hose
fittings
or
the
hose braid.
WARNING: Clean dust
and debris from the hose cover
daily.
Accumulated dust can create
hot
spots in a hose and become
a
fire
hazard.
2.
Clean any dust and debris from the hose cover.
Safety Precautions
Daily Maintenance
Manual
45-21 108 232E
lssued
1/00
@
2000 Nordson Corporallon
All
rights reserved