A
1-6
Safety
Danger
of
Burns
Contact
with hot melt materials or hot areas of the unit may produce a
severe
skin burn.
WARNING: Hot!
Risk of
burns. Wear heat-protective
clothing,
safety goggles, and/or heat-protective gloves depending
on
the
symbols shown.
Be extremely
carefulwhen using
hot melt
material.
Even
solidified
material may
still
be
very
hot.
Always
wear protective clothing which safely covers all exposed parts
of
the
body.
ln case
of burns:
.
lmmediately cool affected skin areas using cold, clean water
.
Do
not
forcefully remove hot melt materialfrom the skin.
.
lmmediately seek medical attention.
Allow only qualified
personnelto
perform
the procedures described
in
this
document. When performing such tasks, wear protective clothing, and
equipment.
WARNING:
Even when
the circuit breaker or main power
switch is
OFF,
the unit
is
still electrically
energized.
Complete
the
following steps prior to maintenance or repair:
Disconnect, lock out, and
tag external power supply
To
ensure
the external power supply is disconnected, attempt to
operate
the
unit.
lf
the unit does not energize, proceed with
maintenance
or repair work.'
lf
the unit energizes, repeat the disconnect, lock out, and tag
procedure.
Re-test
the unit.
a
a
7.
Maintenance/Repair
a
a
AI
EN{2-[XX-SAFEI-1
lssued
11/94
@
'1994
Nordson Corporation
All
rights reserved