Manually Starting The Unit - Nordson 3100V Series Customer Product Manual

Operation
A 4-3
Manually Starting the Unit
lf
you have not programmed your unit to staft automatically; use this
procedure
to manually start your unit. lf you have programmed your unit
to start automatically, you will still need to start the unit manually when
you need to start the unit before it
is
time for automatic stafiup
to occur
you need to start the unit on a day for which the clock is turned off
.
you need to start the unit because the clock was not turned
on
1.
lf
the power is off, press the POWER switch to turn the unit
on.
2.
lf the auto-energize heaters feature is not on, press the HEATERS
key. The
HEATERS light will turn on and unit will begin to heat.
3.
Prepare
each gun
in
your system for
operation as follows:
o
Air-operated guns: turn on the operating
air.
o
Electric guns: turn
on
the gun driver.
o
Hand-operated guns: unlock the trigger.
4.
Piston
pump
units only:
turn on the pump air pressure and adjust
it
to
the setting that works best for your system.
5.
Check the
temperature setting for each heated zone.
6.
Piston
pump
units only: lt
the auto-energize pump feature is not
on,
press the PUMP key after the READY light turns on.
The PUMP light
willturn
on and
the pump will start.
7.
Gear
pump
units only: When the READY light turns on, press the
PUMP
key. The
PUMP light
willturn
on and
the pump will start.
The system is ready for routine operation.
a
a
o
2000 Nordson Corporation
All rights reserved
41-3000v
lssued 5/00
A4EN46-[3V-A-AAXV]-l