Nordson 3100V Series Customer Product Manual page 162

Maintenance
A 5-9
7.
Use one of the
following methods to clean the filter components
WARNING:
Risk of
fire.
Do not
heat Nordson Type
R cleaning
fluid above 246 "C
(475'F).
Do not heat cleaning fluid with an
open
flame or in an unregulated heating device (for example, a
small pan on an unregulated hot plate). A fire hazard exists if
an open flame or an unregulated heating device is used to heat
cleaning
fluid.
Use only
a
controlled heating device (such as a
small, deep fat
fryer
or
thermostatically-controlled hot plate) to
heat the fluid above the melting temperature
of
the hot melt ma-
terial.
CAUTION: Do not use a metal brush to clean a manifold filter
screen.
Doing so can damage the screen and prevent the filter
from operating properly.
Place the
components (except for the o-ring) in a container of
Type
R
cleaning fluid and heat the fluid until it is above the melting
point
of
the adhesive. Scrub the components with
a
fine-bristled
brush.
Remember to scrub the filter screen inside and
out.
Wipe
the
components with a clean, dry cloth.
a
Use a
flameless, electric heat gun or compressed hot air to heat
the
components.
Wipe the components
with a clean, dry cloth.
Use
an ultrasonic cleaner filled with cleaning fluid to soak the
components,
then wipe the components with a clean, dry cloth.
8.
lnspect the filter screen and o-ring for damage. A dent or break in the
filter screen mesh means that the screen
is
damaged beyond repair
and should be replaced.
a
a
@ 1998 Nordson Corporatlon
All rights reserved
41-3000v
lssued 9/98
A5EN-07-[3V-X-AXAX]-5