Control
B
2-37
Operator Panel Removal
WARNING:
Risk of
equipment damage, personal
injury or
death.
Disconnect
and lock out electrical power to the unit,
including inpuVoutput
(l/O) lines.
1.
Place
the unit's POWER switch
in
the off position, disconnect and
lock out
electrical power to the unit
at
the branch circuit disconnect
switch, and disconnect and lock out electrical power supplied through
any l/O wiring.
2.
Open
the electrical
enclosure.
Refer
to
Opening
and Closing the
Electrical Enclosure.
3.
Remove
the power
board.
Refer
to
Power
Board Removalin
Replacing
a Control Assembly Board.
4.
Disconnect
the ribbon cable from XP1 on the control board.
5.
Close the
control-end frame and secure
it
with
the captive screws
6.
See Figure
B
2-10.
Using
a
flat-blade screwdriver and pliers, pull the
operator panel away from the control-end frame and guide the ribbon
cable through
the hole
in
the control-end frame.
4130096A
Fig.
B
2-10
Removing
the Operator
Panel
7.
Use a
citrus industrial cleaner to remove any adhesive that remains
on
the control-end frame; then use denatured alcohol to thoroughly
clean
the residue left by the citrus industrial cleaner.
@000
Nordson
Corporation
All
rights reserved
41-3000y
lssued
5/00
82EN-04-[3V-X-4XXVI-5