Programming Optional Features A 3-29R; Programming System Setttngs Controls A - Nordson 3100V Series Customer Product Manual

lnstallation
A 3-29
Programming Optional
Features
Programming SYSTEM
SETTINGS
Controls
lf
your unit has an optional l/O board, you can program additional
features.
Refer
to
Series
3000V lnput/Output Board in
the
Opfions
section
for information on programming these additionalfeatures.
Use
this procedure to program the SYSTEM SETTINGS features shown
in Table A 3-4.
1.
lf
you have not already done so, turn power on to the unit by pressing
the POWER switch.
2.
See Figure A
3-19.
Press
the Move Up (1) and Move Down (2) keys
untilthe
SYSTETU
SETTINGS light turns on. When you select
SYSTEM SETTINGS, the following occur:
a
a
The
values in the Displays area change
The number in the Selector display changes to
a
feature number.
The Multipurpose display changes to the current value for the
feature selected,
Fig. A
3-19
Selecting SYSTEM SETTINGS Features
1.
Move Up
key
2.
Move
Down key
NOTE:
lf
you have enabled the password feature, you must
change the number
in
the Multipurpose display (500) to the
password (321) and press the Enter key before the system will
allow you to change any SYSTEM SETTINGS features.
1
2
SYSTEM
SETTINGS
,g1o
4103988
@
2000
Nordson
Corporation
All rights reserved
41-3000v
lssued
5/00
A3EN-04-[3V-X-4XXVI-1
3