Lnspecting Hose Electrical Connections - Nordson 3100V Series Customer Product Manual

RTD-Style Hot Melt
Hose
23
5920023
Fig.
5
Proper Hose Fitting
Removal
or Replacement
lnspecting
Hose
Electrical
Connections
Table
4
Wrench Sizes Needed for Tightening Hose Fittings
8.
See
Figure
5.
Tighten any loose connections using two wrenches.
Place one wrench
on the applicator manifold or gun
fitting
and
the
other
wrench
on the hose fitting.
WARNING:
Even when switched off, Nordson applicators
and
hoses contain electrical potentials that can cause death.
Disconnect and lock out
line
voltage to the applicator
when
instructed to
do so.
1.
Disconnect and lock out power to the main circuit breaker for
the
applicator input power line. See Figure
4.
2.
Check that all hose electrical plug pins are in good condition. Repair
any damaged pins. Refer
to
Parts
and Reference Data, Section 6, tor
the required hose end repair
kit.
WARNING:
Vibration, and system heating and
cooling cycles
can loosen connections and cause equipment damage or
electric shock.
3.
Check that all hose electrical plug connections are tight.
Tighten any
loose plugs.
Hose l.D. Size
Gonnector
Wrench
Size
Hose
Fatung
Wrench Size
5/16
in.
s/s
in
11/16
in
s/s in.
11lain
11/ain
O 2U)0 Nordson Corporation
All rights
reserued
108232E
lssued
1/00
Manual 45-21