Connecting The Router To A Network For Out-Of-Band Management - Juniper MX10003 Quick Start Manual

Connecting the Router to a Network for Out-of-Band Management

Copyright © 2017, Juniper Networks, Inc.
Figure 9: Routing and Control Board (RCB) Ports
1 2 3
1— USB port
2— Management ( MGMT ) port
3— Console ( CON ) port
4— SSD LEDs
5— 0 1
SSD slots ( and )
6— MST
Master ( ) LED
7— ALM
Alarm ( ) LED
Connecting the Router to a Network for Out-of-Band Management on page 11
Connecting the Router to a Console Device on page 12
Connecting the Router to External Clocking and Timing Devices on page 13
To connect the RCB to a network for out-of-band management, connect an Ethernet
cable with RJ-45 connectors to the
is provided with the router. To connect to the
NOTE: Use shielded CAT5e cable for the
Turn off power to the management device.
1.
Plug one end of the Ethernet cable
2.
the MGMT port on the RCB interface.
Plug the other end of the cable into the network device.
3.
Figure 10: Out-of-Band Management Cable Connector
Connecting the Router to a Network for Out-of-Band Management
4 5 6 7
14 13 12 11
8— Time of day (
9— BITS port with LEDs
10— Clocking ports
11— OFFLINE
12— ONLINE
13— OK/FAIL
14— RESET
port on the RCB interface. One Ethernet cable
MGMT
port on the RCB faceplate:
MGMT
CON
(Figure 10 on page 11
8 9 10
ToD ) port with LEDs
button
LED
LED
button
and ports on the RCB.
MGMT
shows the connector) into
11