Port-Security Trap - HPE FlexNetwork HSR6800 Security Command Reference

Use undo port-security timer disableport to restore the default.
Syntax
port-security timer disableport time-value
undo port-security timer disableport
Default
The silence period is 20 seconds.
Views
System view
Default command level
2: System level
Parameters
time-value: Specifies the silence period in seconds during which the port remains disabled. The
value range is 20 to 300.
Usage guidelines
If you configure the intrusion protection policy as disabling the port temporarily whenever it receives
an illegal frame, use this command to set the silence period.
Examples
# Configure the intrusion protection policy as disabling the port temporarily whenever it receives an
illegal frame and set the silence period to 30 seconds.
<Sysname> system-view
[Sysname] port-security timer disableport 30
[Sysname] interface gigabitethernet 3/0/1
[Sysname-GigabitEthernet3/0/1] port-security intrusion-mode disableport-temporarily
Related commands
display port-security

port-security trap

Use port-security trap to enable port security traps.
Use undo port-security trap to disable port security traps.
Syntax
port-security trap { addresslearned | dot1xlogfailure | dot1xlogoff | dot1xlogon | intrusion |
ralmlogfailure | ralmlogoff | ralmlogon }
undo port-security trap { addresslearned | dot1xlogfailure | dot1xlogoff | dot1xlogon |
intrusion | ralmlogfailure | ralmlogoff | ralmlogon }
Default
Port security traps are disabled.
Views
System view
Default command level
2: System level
188