Enabling Is-Is Snmp Trap - HPE FlexNetwork HSR6800 Configuration Manual

•
Configure network layer addresses for interfaces to make the neighboring nodes reachable at
the network layer.
•
Enable IS-IS.
Configuration guidelines
•
Do not use FRR and BFD at the same time. Otherwise, FRR might fail to take effect.
•
The automatic backup next hop calculation of FRR and that of TE are mutually exclusive.
Configuring IS-IS FRR to automatically calculate a backup next hop
Step
Enter system view.
1.
Configure the source
2.
address of echo packets.
Enter IS-IS view.
3.
Enable IS-IS FRR to
4.
automatically calculate a
backup next hop.
Configuring IS-IS FRR to designate a backup next hop with a routing policy
You can use the apply fast-reroute backup-interface command to specify a backup next hop in a
routing policy for routes matching specific criteria. For more information about the apply
fast-reroute backup-interface command and routing policy configurations, see "Configuring
routing policies."
To configure IS-IS FRR:
Step
Enter system view.
1.
Configure the source
2.
address of echo packets.
Enter IS-IS view.
3.
Enable IS-IS FRR to
4.
designate a backup next hop
by using a routing policy.

Enabling IS-IS SNMP trap

This task enables IS-IS to generate traps and send them to the information center of the device. The
information center determines whether to output the traps and where to output. For more information
about information center, see Network Management and Monitoring Configuration Guide.
To enable IS-IS SNMP trap:
Step
Enter system view.
1.
Enter IS-IS view.
2.
Command
system-view
bfd echo-source-ip ip-address
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
fast-reroute auto
Command
system-view
bfd echo-source-ip ip-address
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
fast-reroute route-policy
route-policy-name
Command
system-view
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
151
Remarks
N/A
Not configured by default.
N/A
Not configured by default.
Remarks
N/A
Not configured by default.
N/A
Not configured by default.
Remarks
N/A
N/A