Local; Local-Address - HPE FlexNetwork HSR6800 Security Command Reference
Hide thumbs
Also See for FlexNetwork HSR6800:
- Configuration manual (503 pages) ,
- Command reference manual (153 pages) ,
- Product end-of-life disassembly instructions (2 pages)
Table of Contents
Advertisement
Examples
# Set the DPD interval to 1 second for dpd2.
<Sysname> system-view
[Sysname] ike dpd dpd2
[Sysname-ike-dpd-dpd2] interval-time 1
local
Use local to set the subnet type of the local security gateway for IKE negotiation.
Use undo local to restore the default.
Syntax
local { multi-subnet | single-subnet }
undo local
Default
The subnet is a single one.
Views
IKE peer view
Default command level
2: System level
Parameters
multi-subnet: Sets the subnet type to multiple.
single-subnet: Sets the subnet type to single.
Usage guidelines
Use this command to enable interoperability with a NetScreen device.
Examples
# Set the subnet type of the local security gateway to multiple.
<Sysname> system-view
[Sysname] ike peer xhy
[Sysname-ike-peer-xhy] local multi-subnet
local-address
Use local-address to configure the IP address of the local security gateway in IKE negotiation.
Use undo local-address to remove the configuration.
Syntax
local-address [ ipv6 ] ip-address
undo local-address
Default
The primary address of the interface referencing the IPsec policy is used as the local security
gateway IP address for IKE negotiation. Use this command if you want to specify a different address
for the local security gateway.
320
Advertisement
Table of Contents
