Gm Configuration Commands; Client Registration Interface - HPE FlexNetwork HSR6800 Security Command Reference

Views
GDOI KS group view
Default command level
2: System level
Parameters
ip-address: Specifies any valid IPv4 address.
Usage guidelines
Perform this task to specify the source address for GROUPKEY-PUSH protocol packets and
redundancy protocol packets sent by the KS.
Examples
# Specify the source address for the GDOI KS group abc as 11.1.1.1.
<Sysname> system-view
[Sysname]gdoi ks group abc
[Sysname-gdoi-ks-group-abc]source address 11.1.1.1
Related commands
•
gdoi ks group
•
rekey acl
•
rekey transport unicast
•
redundancy

GM configuration commands

client registration interface

Use client registration interface to specify a registration interface for the GM in a GDOI GM group.
The GM uses the registration interface to send packets to the KS.
Use undo client registration interface to delete the registration interface specified for the GM.
Syntax
client registration interface interface-type interface-number
undo client registration interface
Default
The registration interface of a GM is the output interface of the route from the GM to the KS.
Views
GDOI GM group view
Default command level
2: System level
Parameters
interface-type interface-number: Specifies a registration interface by the interface type and number.
Examples
# In GDOI GM group abc, specify interface GigabitEthernet 1/0/1 as the registration interface for the
GM.
500