Stop-Accounting-Buffer Enable (Radius Scheme View) - HPE FlexNetwork HSR6800 Security Command Reference

Default
Every secondary RADIUS server specified in a RADIUS scheme is in active state.
Views
RADIUS scheme view
Default command level
2: System level
Parameters
accounting: Sets the status of the secondary RADIUS accounting server.
authentication: Sets the status of the secondary RADIUS authentication/authorization server.
ip ipv4-address: Specifies the IPv4 address of the secondary RADIUS server.
ipv6 ipv6-address: Specifies the IPv6 address of the secondary RADIUS server.
active: Specifies the active state, the normal operation state.
block: Specifies the blocked state, the out-of-service state.
Usage guidelines
If no IP address is specified, this command changes the status of all configured secondary servers
for authentication/authorization or accounting.
If the device finds that a secondary server in active state is unreachable, the device changes the
status of the secondary server to blocked, starts a quiet timer for the server, and continues to try to
communicate with the next secondary server in active state (a secondary RADIUS server configured
earlier has a higher priority). When the quiet timer of a server times out, the status of the server
changes to active automatically. If you set the status of the server to blocked before the quiet timer
times out, the status of the server cannot change back to active automatically unless you set the
status to active manually. If all configured secondary servers are unreachable, the device considers
the authentication or accounting attempt a failure.
Examples
# Set the status of all secondary servers in RADIUS scheme radius1 to blocked.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] state secondary authentication block
Related commands
•
display radius scheme
•
state primary

stop-accounting-buffer enable (RADIUS scheme view)

Use stop-accounting-buffer enable to enable the device to buffer stop-accounting requests to
which no responses are received.
Use undo stop-accounting-buffer enable to disable the buffering function.
Syntax
stop-accounting-buffer enable
undo stop-accounting-buffer enable
Default
The device buffers stop-accounting requests to which no responses are received.
79