Portal Max-User; Portal Nas-Id - HPE FlexNetwork HSR6800 Security Command Reference

Regardless of whether portal authentication is enabled on an interface, you can only add or remove
a portal-free rule. You cannot modify it.
A Layer 2 interface in an aggregation group cannot be specified as the source interface of a
portal-free rule, and the source interface of a portal-free rule cannot be added to an aggregation
group.
Examples
# Configure a portal-free rule, allowing any packet whose source IP address is 10.10.10.1/24, source
interface is GigabitEthernet 3/0/1, and destination port number is within the range of 8042 to 8050 to
bypass portal authentication.
<Sysname> system-view
[Sysname] portal free-rule 15 source ip 10.10.10.1 mask 24 interface gigabitethernet 3/0/1
destination ip any udp 8042 to 8050
Related commands
display portal free-rule

portal max-user

Use portal max-user to set the maximum number of online portal users allowed in the system.
Use undo portal max-user to restore the default.
Syntax
portal max-user max-number
undo portal max-user
Default
The maximum number of portal users is that supported by the system.
Views
System view
Default command level
2: System level
Parameters
max-number: Maximum number of online portal users allowed in the system. The value range for the
max-number argument is 1 to 64000.
Usage guidelines
If the maximum number of portal users specified in the command is less than that of the current
online portal users, the command can be executed successfully and does not impact the online
portal users, but the system does not allow new portal users to log in until the number drops down
below the limit.
Examples
# Set the maximum number of portal users allowed in the system to 100.
<Sysname> system-view
[Sysname] portal max-user 100

portal nas-id

Use portal nas-id to specify the NAS ID value carried in a RADIUS request.
160