Dpd - HPE FlexNetwork HSR6800 Security Command Reference

Field
remote id
local ip
remote ip
connection id
authentication-method
authentication-algorithm
encryption-algorithm
life duration(sec)
remaining key duration(sec)
exchange-mode
diffie-hellman group
nat traversal
Related commands
•
ike proposal
•
ike peer

dpd

Use dpd to apply a DPD detector to an IKE peer.
Use undo dpd to remove the application.
Syntax
dpd dpd-name
undo dpd
Default
No DPD detector is applied to an IKE peer.
Views
IKE peer view
Default command level
2: System level
Parameters
dpd-name: Specifies the DPD detector name, a string of 1 to 32 characters.
Examples
# Apply dpd1 to IKE peer peer1.
<Sysname> system-view
[Sysname] ike peer peer1
[Sysname-ike-peer-peer1] dpd dpd1
Description
Identifier of the remote security gateway.
IP address of the local gateway.
IP address of the remote gateway.
Identifier of the IKE SA and IPsec SA.
Authentication method used by the IKE proposal.
Authentication algorithm used by the IKE proposal.
Encryption algorithm used by the IKE proposal.
Lifetime of the ISAKMP SA in seconds.
Remaining lifetime of the ISAKMP SA in seconds.
IKE negotiation mode in phase 1.
DH group used for key negotiation in IKE phase 1.
Whether NAT traversal is enabled.
311