Portal Auth-Network - HPE FlexNetwork HSR6800 Security Command Reference

MAC
---------------------------------------------------------------------
000d-88f8-0eac
Total 2 user(s) matched, 2 listed.
Table 19 Command output
Field
Index
State
SubState
ACL
Work-mode
VPN instance
MAC
IP
Vlan
Interface
Total 2 user(s) matched, 2 listed

portal auth-network

Use portal auth-network to configure a portal authentication source subnet on an interface. You
can use this command to configure multiple portal authentication source subnets on an interface.
Then, only HTTP packets from the subnets can trigger portal authentication on the interface. If an
unauthenticated user is not on any authentication source subnet, the access device discards all the
user's HTTP packets that do not match any portal-free rule.
Use undo portal auth-network to remove a specific portal authentication source subnet or all portal
authentication subnets.
Syntax
portal auth-network network-address { mask-length | mask }
undo portal auth-network { network-address | all }
Default
The portal authentication source subnet is 0.0.0.0/0, meaning that users in all subnets must pass
portal authentication.
Views
Interface view
Default command level
2: System level
Parameters
network-address: IP address of the authentication source subnet.
IP
3.3.3.3 0
Description
Index of the portal user.
Current status of the portal user.
Current sub-status of the portal user.
Authorization ACL of the portal user.
User's working mode:
•
Primary.
•
Secondary.
•
Stand-alone.
MPLS L3VPN to which the portal server belongs.
MAC address of the portal user.
IP address of the portal user.
VLAN to which the portal user belongs.
Interface to which the portal user is attached.
Total number of portal users.
Vlan Interface
GigabitEthernet3/0/2
155