Reverse-Route Tag - HPE FlexNetwork HSR6800 Security Command Reference

When you change the route preference, static IPsec RRI deletes all static routes it has created and
creates new static routes. In contrast, dynamic IPsec RRI applies the new preference only to
subsequent static routes. It does not delete or modify static routes it has created.
Examples
# Set the preference to 100 for static routes populated by IPsec RRI.
<Sysname>system-view
[Sysname] ipsec policy 1 1 isakmp
[Sysname-ipsec-policy-isakmp-1-1] reverse-route preference 100
Related commands
reverse-route

reverse-route tag

Use reverse-route tag to set a route tag for the static routes created by IPsec RRI. This tag helps in
implementing flexible route control through routing policies.
Use undo reverse-route tag to restore the default.
Syntax
reverse-route tag tag-value
undo reverse-route tag
Default
The tag value is 0 for the static routes created by IPsec RRI.
Views
IPsec policy view
Default command level
2: System level
Parameters
tag-value: Sets a route tag for the static routes. The value range is 1 to 4294967295.
Usage guidelines
This command makes sense only when used together with the reverse-route command.
When you change the route tag, static IPsec RRI deletes all static routes it has created and creates
new static routes. In contrast, dynamic IPsec RRI applies the new route tag only to subsequent static
routes. It does not delete or modify static routes it has created.
For information about routing policies, see Layer 3—IP Routing Configuration Guide.
Examples
# Set the tag value to 50 for the static routes created by IPsec RRI.
<Sysname>system-view
[Sysname] ipsec policy 1 1 isakmp
[Sysname-ipsec-policy-isakmp-1-1] reverse-route tag 50
Related commands
reverse-route
291