Layer 3 Routing Commands
The sections that follow describe commands that conform to the OSI model's
Network Layer (Layer 3). Layer 3 Routing commands enable routing
protocols to perform a series of exchanges over various data links to route data
between any two nodes in a network. These commands define the addressing
and routing structure of the Internet.
The Dell EMC N1100-ON Series switches do not support routing.
This section of the document contains the following Layer 3 topics:
ARP Commands
Bidirectional Forwarding Detection
Commands
Border Gateway Protocol Commands
BGP Routing Policy
DVMRP Commands
IGMP Commands
IGMP Commands
IGMP Proxy Commands
IP Helper/DHCP Relay Commands
IP Routing Commands
IPv6 Routing Commands
Loopback Interface Commands
IP Multicast Commands
IPv6 Multicast Commands
OSPF Commands
OSPFv3 Commands
Router Discovery Protocol Commands
Routing Information Protocol Commands
Tunnel Interface Commands
Virtual Router Commands
Virtual Router Redundancy Protocol
Commands
–
Layer 3 Routing Commands
7
1187