Configuring A Protection Interface In An Aps Group - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l local-ip: Indicates the IP address of the local router . Usually, the value is the IP address of
----End

3.3.3 Configuring a Protection Interface in an APS Group

The protection and working interfaces must be added to the same APS group.
Context
Do as follows on the router that requires APS:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface
or
controller cpos
The interface view is displayed.
Step 3 Run:
aps group
An APS group is created and an interface is added to the APS group.
The working and protection interfaces must be added to the same APS group.
Step 4 Run:
aps protect
The interface added to the APS group is specified as a protection interface.
l peer-ip: Indicates the IP address of the Router where the working interfaces that are in the
l local-ip: Indicates the IP address of the local router . Usually, the value is the IP address of
Step 5 (Optional) Run:
aps signal-low-priority
Issue 02 (2011-09-10)
the loopback interface on the router.
interface-type interface-number
cpos-number
NOTE
Only ATM interfaces, and CPOS interfaces on the LPUF-10 support APS.
ATM interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
group-id
CAUTION
peer-ip local-ip
same APS group as the protect group is located. Usually, the value is the IP address of the
loopback interface on the Router.
the loopback interface on the router.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 APS Configuration
43