Huawei NetEngine80E Configuration Manual - Reliability page 580

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Procedure
l
l
Issue 02 (2011-09-10)
Figure 9-6 Networking diagram for priority-based frame loss measurement on a VLL
CE1
User
Network
Enable on-demand single-ended frame loss measurement.
NOTE
Do as follows on the device that initiates on-demand single-ended frame loss measurement on a PW:
– Enable on-demand single-ended frame loss measurement on a PW.
1. Run:
system-view
The system view is displayed.
2. Run:
cfm md md-name
The MD view is displayed.
3. Run:
ma ma-name
The MA view is displayed.
4. Run:
loss-measure single-ended
mep mep-id mep-id ] interval { 1000 | 10000 } count count-value
On-demand single-ended frame loss measurement is enabled on a PW.
NOTE
l If the local MEP has not learned the MAC address of the remote MEP, specify the
destination MAC address for the single-ended frame loss measurement.
l If the local MEP has learned the MAC address of the remote MEP or the remote MEP
has been bound to the MAC address of the local MEP, specify the remote MEP ID for
the single-ended frame loss measurement.
Enable proactive single-ended frame loss measurement.
NOTE
Proactive single-ended frame loss measurement is PW-specific. Do as follows on the device that
initiates proactive single-ended frame loss measurement on a PW:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
P
PE1
Y.1731
mep mep-id mep-id [ mac mac-address | remote-
9 Y.1731 Configuration
CE2
PE2
User
Network
MEP
Priority 1
Priority 2
563