Configuring The Association Between The Bfd Status And The Sub-Interface Status - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Prerequisite
The configurations of the association between the BFD status and the interface status function
are complete.
Procedure
l
l
----End
Example
After the configuration, running the
is displayed in the field of "Proc interface status" of corresponding sessions.
--------------------------------------------------------------------------------
Session MIndex : 256
--------------------------------------------------------------------------------
Local Discriminator
Session Detect Mode
BFD Bind Type
Bind Session Type
Bind Peer Ip Address
NextHop Ip Address
Bind Interface
FSM Board Id
Min Tx Interval (ms)
Actual Tx Interval (ms): 10
Local Detect Multi
Echo Passive
Destination Port
Proc interface status : Enable
WTR Interval (ms)
Active Multi
Last Local Diagnostic
Bind Application
Session TX TmrID
Session Init TmrID
Session Echo Tx TmrID
PDT Index
Session Description
--------------------------------------------------------------------------------
5.5 Configuring the Association Between the BFD Status
and the Sub-Interface Status
By associating the BFD session status with the sub-interface status, you can trigger fast route
convergence. This function is applicable to the single-hop BFD session that detects default
multicast IP addresses.
Issue 02 (2011-09-10)
Run the display bfd session
ip [ vpn-instance vpn-instance-name ] | static } [ verbose ] [ slot slot-id ] command to
check the BFD session.
Run the display bfd session
name ] } [ verbose ] [ slot slot-id ] command to check the BFD6 session.
Total UP/DOWN Session Number : 1/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
{ all | discriminator discr-value | dynamic | peer-ip peer-
{ all | static | peer-ipv6 peer-ipv6 [ vpn-instance vpn-instance-
display bfd session
(One Hop) State : Up
: 22 Remote Discriminator
: Asynchronous Mode Without Echo Function
: Interface(GigabitEthernet2/0/0)
: Static
: 224.0.0.184
: 224.0.0.184
: GigabiEthernet2/0/0
: 2 TOS-EXP
: 10 Min Rx Interval (ms)
Actual Rx Interval (ms) : 10
: 3 Detect Interval (ms)
: Disable Acl Number
: 3784 TTL
Process PST
: --
: 3
: No Diagnostic
: No Application Bind
: -- Session Detect TmrID
: -- Session WTR TmrID
: --
: FSM-0 | RCV-0 | IF-0 | TOKEN-0
: --
5 BFD Configuration
command, you can view that "Enable"
Name : test
: 11
: 7
: 10
: 30
: --
: 255
: Disable
: --
: --
251