Configuring A Protection Interface In An Aps Group - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
The system view is displayed.
Step 2 Run:
interface
or
controller cpos
The interface view is displayed.
Step 3 Run:
aps group
An APS group is created and an interface is added to the APS group.
Step 4 Run:
aps working
The interface added to the APS group is specified as a working interface.
----End

3.2.3 Configuring a Protection Interface in an APS Group

The protection and working interfaces must be added to the same APS group.
Context
Do as follows on the router that requires APS:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface
or
controller cpos
The interface view is displayed.
Step 3 Run:
aps group
An APS group is created and an interface is added to this APS group.
Issue 02 (2011-09-10)
interface-type interface-number
cpos-number
NOTE
Only ATM interfaces, and CPOS interfaces on the LPUF-10 support APS.
ATM interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
group-id
interface-type interface-number
cpos-number
NOTE
Only ATM interfaces, and CPOS interfaces on the LPUF-10 support APS.
ATM interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
group-id
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 APS Configuration
36