Configuring Dmm Reception On A Remote Mep; Enabling Two-Way Frame Delay Measurement On A Vpls Network - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability

9.9.3 Configuring DMM Reception on a Remote MEP

Two-way frame delay measurement can work properly only when DMM reception is configured
on a remote MEP.
Context
Do as follows on the device where a remote MEP is located.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm md
The MD view is displayed.
Step 3 Run:
ma
The MA view is displayed.
Step 4 Run the following commands as needed:
l To detect a PW, run the
----End
9.9.4 Enabling Two-Way Frame Delay Measurement on a VPLS
Network
VPLS implements MP2MP VPNs so that there may be multiple PWs in the same VSI. To make
accurate statistics of the delay in bidirectional frame transmission over a PW, configure two-
way frame delay measurement on a VPLS network.
Context
On-demand OAM refers to OAM actions that are initiated by manual intervention for a limited
time to carry out diagnostics. On-demand OAM results in singular or periodic OAM actions
during the diagnostics time. One-way frame delay measurement on a VPLS network is on-
demand OAM. To implement singular or periodic frame delay measurement on a PW, configure
on-demand two-way frame delay measurement on a VPLS network.
l
Procedure
l
Issue 02 (2011-09-10)
md-name
ma-name
command to configure DMM reception on a remote MEP.
To make frame delay measurement on a PW, do as follows on the device that initiates two-
way frame delay measurement:
Enable on-demand two-way frame delay measurement on a PW.
1. Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
delay-measure two-way receive
9 Y.1731 Configuration
peer-ip peer-ip vc-id vc-id
599