Huawei NetEngine80E Configuration Manual - Reliability page 362

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
[RouterA-GigabitEthernet2/0/0.1] arp broadcast enable
[RouterA-GigabitEthernet2/0/0.1] quit
# Configure Router B.
[RouterB] interface gigabitethernet 2/0/0.1
[RouterB-GigabitEthernet2/0/0.1] qinq vrrp pe-vid 100 ce-vid 10
[RouterB-GigabitEthernet2/0/0.1] vrrp vrid 1 virtual 100.1.1.100
[RouterB-GigabitEthernet2/0/0.1] vrrp vrid 1 track bfd-session 2
[RouterB-GigabitEthernet2/0/0.1] arp broadcast enable
[RouterB-GigabitEthernet2/0/0.1] quit
Step 8 Verify the configuration.
Run the display vrrp command. You can view that the status of the BFD session tracked by
VRRP backup group 1 is Up. Take the display on Router A as an example.
[RouterA] display vrrp
GigabitEthernet1/0/0 | Virtual Router 1
Config track link-bfd down-number : 0
----End
Configuration Files
l
Issue 02 (2011-09-10)
State
Virtual IP
PriorityRun
PriorityConfig
MasterPriority
Preempt
TimerRun
TimerConfig
Virtual Mac
Check TTL
Config type
Track BFD
BFD-session state : UP
Configuration file of Router A
#
sysname RouterA
#
bfd
#
interface GigabitEthernet 1/0/0
undo shutdown
ip address 192.168.2.1 24
#
interface GigabitEthernet2/0/0
undo shutdown
mode user-termination
#
interface GigabitEthernet2/0/0.1
undo shutdown
control-vid 1 qinq-termination
qinq termination pe-vid 100 ce-vid 10
qinq vrrp pe-vid 100 ce-vid 10
ip address 100.1.1.1 24
vrrp vrid 1 virtual 100.1.1.100
vrrp vrid 1 priority 160
vrrp vrid 1 track bfd-session 1
arp broadcast enable
#
bfd atob bind peer-ip default-ip interface gigabitethernet 2/0/0.1
discriminator local 1
discriminator remote 2
qinq pe-vid 100 ce-vid 10
commit
#
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: Master
: 100.1.1.100
: 160
: 160
: 160
: YES Delay Time : 0
: 1
: 1
: 0000-5e00-0101
: YES
: normal-vrrp
: 1
5 BFD Configuration
Priority reduced : 10
345