Example For Configuring Vrrp In Load Balancing Mode - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l

4.14.2 Example for Configuring VRRP in Load Balancing Mode

In this example, by configuring a VRRP backup group in load balancing mode, you can provide
the mutual backup function to devices in the VRRP backup group and balance network traffic
among these devices.
Networking Requirements
As shown in
l
l
l
Issue 02 (2011-09-10)
interface Pos1/0/0
link-protocol ppp
undo shutdown
ip address 192.168.2.1 255.255.255.0
#
ospf 1
area 0.0.0.0
network 192.168.2.0 0.0.0.255
network 10.1.1.0 0.0.0.255
#
return
Configuration file of Router C
#
sysname RouterC
#
interface Ethernet3/0/0
undo shutdown
ip address 20.1.1.1 255.255.255.0
#
interface Pos1/0/0
link-protocol ppp
undo shutdown
ip address 192.168.1.2 255.255.255.0
#
interface Pos2/0/0
link-protocol ppp
undo shutdown
ip address 192.168.2.2 255.255.255.0
#
ospf 1
area 0.0.0.0
network 192.168.1.0 0.0.0.255
network 192.168.2.0 0.0.0.255
network 20.1.1.0 0.0.0.255
#
return
NOTE
POS interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
Figure 4-6.
Router A serves as the master router of backup group 1 and the backup router of backup
group 2.
Router B serves as the master router of backup group 2 and the backup router of backup
group 1.
Host A in the internal network takes backup group 1 as its gateway and Host C takes backup
group 2 as its gateway to share the traffic and backup each other.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VRRP Configuration
139