Checking The Configuration; Maintaining Vrrp; Monitoring The Vrrp Running - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
The default VRRP version is v2. If the VRRP version is switched to v3, the default mode for
sending advertisement packets is v3-only.
----End

4.12.3 Checking the Configuration

You can view VRRP version information to check whether the configuration is successful.
Prerequisite
The configurations of VRRP version upgrade are complete.
Procedure
l
----End
Example
After the configuration, run the
view that the VRRP protocol version is v3 and the mode for sending Advertisement packets is
send v3 only.
<HUAWEI> display vrrp protocol-information
VRRP protocol information is shown as below:

4.13 Maintaining VRRP

This section describes how to maintain VRRP. Detailed operations include deleting VRRP
statistics, and monitoring the VRRP operation status.

4.13.1 Monitoring the VRRP Running

By monitoring the VRRP operation status, you can view information about VRRP during the
operation.
Context
In routine maintenance, you can run the following command in any view to display the running
status of VRRP.
Procedure
l
l
----End
Issue 02 (2011-09-10)
Run the display vrrp protocol-information
VRRP protocol version : v3
Send advertisement packet mode : send v3 only
Run the display vrrp [ interface interface-type interface-number [ virtual-router-id ] ]
[ brief ] command in any view to check the current running status and parameters of VRRP.
Run the display vrrp6
id ] ] [ brief ] command in any view to check the status and configurations of the VRRP6
backup group.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
command to view VRRP version information.
display vrrp protocol-information
[ interface interface-type interface-number [ vrid virtual-router-
4 VRRP Configuration
command, and you can
134