Configuring Dmm Reception On A Remote Device - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Table 9-8 Packet processing on an inbound interface
Inbound Interface
Type
Dot1q sub-interface
Dot1q termination
sub-interface
QinQ termination
sub-interface (in
symmetry mode)
QinQ termination
sub-interface (in
asymmetry mode)
Table 9-9 Packet processing on an outbound interface
Outbound
Interface Type
Dot1q sub-interface
Dot1q termination
sub-interface
QinQ termination
sub-interface (in
symmetry mode)
QinQ termination
sub-interface (in
asymmetry mode)
----End

9.5.3 Configuring DMM Reception on a Remote Device

Two-way frame delay measurement can work normally only when DMM reception is configured
on a remote device.
Context
Do as follows on the device where the remote MEP is located:
Issue 02 (2011-09-10)
Raw Encapsulation
(Ethernet Encapsulation)
Removes one tag.
Removes one tag.
Removes the outer tag.
Removes both the inner and
outer tags.
Raw Encapsulation
(Ethernet Encapsulation)
Adds one tag.
Adds one tag.
Adds an outer tag.
Adds two tags.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Y.1731 Configuration
Tagged Encapsulation
(VLAN Encapsulation)
Keeps the tag unchanged.
Keeps the tag unchanged.
Keeps both inner and outer tags
unchanged.
Removes both inner and outer
tags, and then adds one tag.
Tagged Encapsulation
(VLAN Encapsulation)
Replaces the VLAN ID in the tag
contained in a packet with the
local VLAN ID.
Replaces the VLAN ID in the tag
contained in a packet with the
local VLAN ID.
Replaces the VLAN ID in the
outer tag contained in a packet
with the local VLAN ID.
Removes the outer tag and then
adds two tags.
580