Configuring Vrrp On Vlanif; Optional) Configuring The Sending Mode Of Vrrp Packets In Super-Vlan - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Data Preparation
To configure VRRP on the VLANIF interface, you need the following data.
No.
1
2
3
4

4.7.2 Configuring VRRP on VLANIF

By creating a VRRP backup group on VLANIF interfaces, you can use the standby VLANIF
interface to take over network traffic when the active VLANIF interface goes Down.
Context
Do as follows on a router on which VRRP runs on the VLANIF interface:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif
The VLANIF interface view is displayed.
Step 3 Run:
vrrp vrid
A backup group is created and its virtual IP address is specified.
Step 4 Run:
vrrp vrid
The priority of the router in the backup group is configured.
----End
4.7.3 (Optional) Configuring the Sending Mode of VRRP Packets
in Super-VLAN
You can configure the sending mode of VRRP advertisement packets for a super VLAN on
VLANIF interfaces as required.
Issue 02 (2011-09-10)
Data
Super-VLAN ID
Sub-VLAN ID
Backup group ID
Virtual IP address of the backup group
vlan-id
virtual-router-id virtual-ip virtual-address
virtual-router-id priority priority-value
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VRRP Configuration
112