Testing The Packet Loss Ratio On The Physical Link; Establishing The Configuration Task - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
<HUAWEI> display efm interface gigabitethernet1/0/0

8.4 Testing the Packet Loss Ratio on the Physical Link

By testing the packet loss ratio on a physical link, you can take effective measures to ensure
better performance of the link.

8.4.1 Establishing the Configuration Task

Before testing the packet loss ratio on a physical link, familiarize yourself with the applicable
environment, complete the pre-configuration tasks, and obtain the data required for the
configuration. This will help you complete the configuration task quickly and accurately.
Applicable Environment
Forwarding of service data is affected after EFM OAM remote loopback is enabled. Enable EFM
OAM remote loopback on the link that need not forward service data.
You can perform the configuration task to detect the packet loss ratio on a link.
As shown in
loopback on GE 1/0/1 on Router A. Send test packets from Router A to RouterB. You can get
the packet loss ratio on the link by observing the receiving of test packets on Router A.
Issue 02 (2011-09-10)
Item
----------------------------------------------------------
Interface:
EFM Enable Flag:
Mode:
OAMPDU MaxSize:
OAMPDU Timeout:
ErrCodeNotification:
ErrCodePeriod:
ErrCodeThreshold:
ErrFrameNotification:
ErrFramePeriod:
ErrFrameThreshold:
ErrFrameSecondNotification:
ErrFrameSecondPeriod:
ErrFrameSecondThreshold:
Hold Up Time:
ThresholdEvtTriggerErrDown:
TriggerIfDown:
TriggerMacRenew:
RemoteMAC
Remote EFM Enable Flag
Remote Mode
Remote MaxSize
Remote State:
CAUTION
Figure 8-4, enable EFM OAM on Router A and RouterB and enable remote
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
GigabitEthernet1/0/0
enable
active
128
3000
enable
1
1
enable
1
1
enable
60
1
0
enable
disable
disable
00e0-fc7f-7258
enable
passive
128
--
8 Ethernet OAM Configuration
398