Checking The Configuration - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run the following command as needed:
l To enter the MEG view and enable AIS, run:
l To enter an interface view and enable AIS, run:
Step 3 (Optional) Run:
ais exp
The priority of AIS PDUs is configured.
Step 4 (Optional) Run:
ais interval
The interval between AIS PDU transmissions is set.
Step 5 Run:
ais enable
AIS is enabled.
----End

10.2.8 Checking the Configuration

After configuring MPLS-TP OAM functions for an LSP, you can view performance statistics
and fault information about the LSP.
Prerequisite
All configurations of MPLS-TP OAM functions for an LSP are complete.
Procedure
l
l
l
l
l
----End
Issue 02 (2011-09-10)
If the RMEP receives no AIS packet within a period 3.5 times the interval between AIS
packet transmissions after an AIS fault is detected, it will resume its original state.
mpls-tp meg meg-name
interface interface-type interface-number
exp-value
interval-value
Run the display mpls-tp oam ais
Run the display mpls-tp oam current-alarm
a MEG.
Run the display mpls-tp oam me
remote-mep-id ] command to check ME information about the MEG.
Run the display mpls-tp oam meg
Run the display mpls-tp oam statistic-type
performance statistics.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 MPLS-TP OAM Configuration
command to check the AIS configuration on a device.
command to check alarm information about
meg meg-name [ mep-id mep-id | remote-mep-id
command to check MEG information on the device.
command to check MPLS-TP OAM
673