Enabling One-Way Frame Delay Measurement On A Vpls Network - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Context
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm md
The MD view is displayed.
Step 3 Run:
ma
The MA view is displayed.
Step 4 Run the following commands as needed:
l During the configuration of one-way frame delay measurement on a PW, run the
----End
9.8.4 Enabling One-Way Frame Delay Measurement on a VPLS
Network
VPLS provides MP2MP VPNs so that there may be multiple PWs between devices configured
with the same VSI. To make accurate statistics of the delay in unidirectional frame transmission
over a PW, configure one-way frame delay measurement on a VPLS network.
Context
On-demand OAM refers to OAM actions that are initiated by manual intervention for a limited
time to carry out diagnostics. On-demand OAM results in singular or periodic OAM actions
during the diagnostics time. One-way frame delay measurement on a VPLS network is on-
demand OAM. To implement singular or periodic frame delay measurement on a PW, configure
on-demand one-way frame delay measurement on a VPLS network.
l
Procedure
l
Issue 02 (2011-09-10)
To make one-way frame delay measurement on a PW, do as follows on a remote PE:
md-name
ma-name
measure one-way receive
reception.
To make one-way frame delay measurement on a PW, do as follows on the PE that initiates
the frame delay measurement:
Enable on-demand one-way frame delay measurement on a PW.
1. Run:
system-view
The system view is displayed.
2. Run:
cfm md md-name
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
peer-ip peer-ip vc-id vc-id command to configure DM frame
9 Y.1731 Configuration
delay-
595