Optional) Configuring Member Vrrp Backup Groups And Binding Them To The Mvrrp Backup Group - Huawei NetEngine80E Configuration Manual - Reliability
Hide thumbs
Also See for NetEngine80E:
- Configuration manual - reliability (1432 pages) ,
- Configuration manual (1301 pages) ,
- Installation manual (169 pages)
Table of Contents
Advertisement
HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
----End
4.11.3 (Optional) Configuring Member VRRP Backup Groups and
Binding them to the mVRRP Backup Group
Through the bindings between member VRRP backup groups and the mVRRP backup group,
the state machines of member VRRP backup groups can be consistent with the state machine of
the mVRRP backup group.
Context
Do as follows on each router on which the member VRRP backup groups need to be bound to
an mVRRP backup group.
Procedure
l
l
Issue 02 (2011-09-10)
5.
Run:
admin-vrrp6 vrid
This VRRP6 backup group is configured as an mVRRP6 backup group.
For VRRP for IPv4:
1.
Run:
system-view
The system view is displayed.
2.
Run:
interface
interface-type interface-number[.subinterface-number ]
The interface view of a VRRP member is displayed.
3.
Run:
vrrp vrid
virtual-router-id virtual-ip virtual-address
A backup group is created with a virtual IP address.
The status of the member VRRP backup group is determined by the mVRRP backup
group. Therefore, the member VRRP backup group needs not a priority.
4.
Run:
vrrp vrid
virtual-router-id1 track admin-vrrp interface interface-type
interface-number [ .subinterface-number ] vrid virtual-router-id2
The member VRRP backup group is bound to the mVRRP backup group.
After the member VRRP backup group is bound to the mVRRP backup group, the
state machine of the member VRRP backup group becomes dependent. That is, the
member VRRP backup group deletes the protocol timer, and no longer sends or
receives packets, and implements its state machine by directly copying the status of
the mVRRP backup group. The backup member can be bound to only one mVRRP.
NOTE
Only a single member VRRP backup group can be configured on a single interface.
For VRRP for IPv6:
1.
Run:
system-view
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
virtual-router-id [ ignore-if-down ]
4 VRRP Configuration
129
Advertisement
Table of Contents
