Configuring A Dialer Interface - Huawei AR530 Series Configuration Manual

Huawei AR530&AR550 Series Industrial Switch Routers
Configuration Guide - WAN
l

3.5.1.1 Configuring a Dialer Interface

Context
Before configuring the PPPoE client, you need to configure a dialer interface and a dialer bundle
for the dialer interface.
The device functioning as a PPPoE client supports only resource-shared DCC (RS-DCC).
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
dialer-rule
The dialer rule view is displayed.
Step 3 Run:
dialer-rule dialer-rule-number { acl { acl-number | name acl-name } | ip { deny |
permit } | ipv6 { deny | permit } }
A dialer ACL is configured.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
interface dialer number
A dialer interface is created and the dialer interface view is displayed.
Step 6 Run:
dialer user user-name
A dialer user name is created.
Step 7 (Optional) Run:
dialer retry limit counts quiet-period period
The quiet duration and retransmission times in the quiet duration are set.
Step 8 Run:
dialer-group group-number
A dialup group that the dialer interface belongs to is configured.
The value of group-number must be the same as the value of dialer-rule-number set in step 3.
Issue 01 (2014-11-30)
Powering on the device
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 PPPoE Configuration
75